RBT® Curved Bow

HIPERTOUCH Genesis: “I got the Genesis for my AR10 (716 Sig)… I was completely blown away, as was the target! The very first shot was quite a surprise as I put the tip of my finger lightly on the trigger (as I could tell putting it together it was going to be a lot lighter than the stock one I took out). I just “thought fire” and the thought went from my brain to the firing pin, seeming to bypass the trigger. Later I found that I could not outpace the fire control I had installed. If you’re worried about getting your money’s worth out of this (as I was), I say now that it was WORTH EVERY CENT SPENT!! (even the shipping)”

HIPERTOUCH Elite: “I just installed a Hyperfire Elite trigger in my AR-10. My goal was to cure some fail to fire issues due to light primer strikes using some foreign military surplus ammo. I have only installed an AR trigger once before and was thinking the Hyperfire trigger could be a problem for me to install. It was way easier than I thought. I did learn one trick to pass along. The trigger and hammer installation is very straight forward. Compressing the coil springs looked like a problem area. I used a 5/32 inch pin punch (flat working end) and cupped my free hand over the spring assembly to prevent lost springs. Success on the first attempt with no flying parts. The trick is to position the yoke just above the notch where it will rest. Push straight in and slightly downward and it falls right into place. The difference between the Elite trigger and military stock trigger is amazing.”